![]() |
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 | ||
FF.Com.Au Hardcore
Join Date: Apr 2006
Location: Adealide, SA
Posts: 1,354
|
I was doing a diff service on my AU XR6 HP today. I noticed a fair bit of oil around the filler plug and two gaskets. I now know it was because the thread in the diff housing where the plug goes, is stripped.
The AU ones are alloy i believe. Any suggestions. I have put it back in with new double gaskets and some Teflon tape. It tightened up a reasonable way. Not sure if this will last or i need to get it helicoiled. I would replace the hat but I am under the impression that the AU XR ones are not only alloy but have the watts pin at a different angle for the suspension so i couldn't use any old diff hat? |
||
![]() |
![]() ![]() |
![]() |
#2 | ||
RAGE Engineering
Join Date: Dec 2004
Location: Melbourne
Posts: 651
|
I have exactly the same problem, but on a standard diff. The good news is that the diff is very low pressure - so sealing should not be an issue. Not sure if Heli Coils come that large? Would be good if they did - let us know how you get on on that front.
I'm heading to the wreckers for a new diff cover. Oh and yes - I do believe the watts link pivot point was lower on XR's, so pay careful attention to that. What a PITA.
__________________
If it doesn't fit, use a BIGGER hammer |
||
![]() |
![]() ![]() |
This user likes this post: |